Filter
Top Products
158 SALES: 0870 90 10 750 Dual Trunk E1 Router User’s Guide
Dual Trunk E1 Router
neighbor
Use the neighbor command to specify a neighbor router. It is used for each connected point-to-point link. Use the no parameter to
disable the specific router.
Command Syntax
(no) neighbor A.B.C.D
A.B.C.D is an IP address of a neighboring router with which the routing information will be exchanged.
Command Mode: configuration mode
Examples
neighbor 1.1.1.
network
Use the network command to specify a network as one that runs Routing Information Protocol (RIP). Use the no parameter to
remove the specified network as one that runs RIP.
Command Syntax
(no) network [A.B.C.D(/M)]|IFNAME
A.B.C.D(/M) - specifies the IP address prefix and length of this IP network.
IFNAME - alphanumeric string specifies the interface name.
Command Mode: Router Configuration
Examples
network 10.0.0.0/8
network eth0
passive-interface
Use the passive-interface command to enable suppression of routing updates on an interface.
Use the no form of this command to disable this function
Command Syntax
(no) passive-interface IFNAME
IFNAME - specifies the interface name.
Command Mode: Router Configuration
Examples
passive-interface eth0
route
Use the route command to configure static RIP routes.
Use the no form of the command to disable this function.
Command Syntax
(no) route A.B.C.D/M
A.B.C.D(/M) - specifies the IP address prefix and length
Command Mode: Router Configuration
Examples
route 1.2.3.4/8
Usage
router rip
...
version 1
network 10.10.10.0/24
network 10.10.11.0/24
neighbor 10.10.10.10...
ripd(config-router)# route 10.10.10.0/24...
version 1
network 10.10.10.0/24
network 10.10.11.0/24
route 10.10.10.0/24