Filter
Top Products
39
CHAPTER 4: Operation: Hardware and Keyboard Commands
4.3 The Commands in Detail
4.3.1 S
ELECTING A
P
ORT FROM THE
S
HARED
K
EYBOARD
To select a port from your keyboard, press and release your keyboard’s left Control
key ([Ctrl]), then type in the port number:
If “Maximum Ports” is set to 1 to 9: The ServSwitch will immediately switch to the
desired port when you press the one-digit number’s numeral key.
If “Maximum Ports” is set to 10 to 99: The ServSwitch will immediately switch to
the desired port when you press the two-digit number’s second numeral key. For
single-digit ports, you can enter the number by including a leading zero (“01” for
port 1) or by pressing [Enter] after you press the single numeral key. If you press
the key of only one digit, and do not follow it with [Enter], the Switch will wait two
seconds for you to press [Enter] or another numeral key; then, if no key is pressed,
it will switch immediately to the single-digit port.
If “Maximum Ports” is set to 100 to 256: The ServSwitch will immediately switch
to the desired port when you press the three-digit number’s third numeral key. For
single- and double-digit ports, you can enter the number by including one or two
leading zeros (“001” for port 1 or “027” for port 27) or by pressing [Enter] after
you press the single or second numeral key. As noted above, the Switch will wait
two seconds for you to enter another digit, then will switch to the partially entered
port number.
4.3.2 S
WITCHING TO THE
N
EXT OR
P
REVIOUS
P
ORT
From the keyboard you can go forward or backward through the ServSwitch’s ports
by selecting either the next or the previous port respectively. To switch to the next
port, press and release the left Control key ([Ctrl]), then press the plus key (the
key at the top of the keyboard marked with [=] and [+]). To switch to the previous
port, press and release [Ctrl], then press the minus key (the key at the top of the
keyboard marked with [–] and [_]). The command is not case-sensitive. Do not use
the [+] and [–] keys on the keyboard’s numeric pad; the Switch doesn’t recognize
these.
You can also select the next or previous port manually from the ServSwitch’s
front panel by pushing the button labeled “
ᮡ” or “ᮢ” respectively (“+” or “–” on
the 2-port units). Each time you press the button, the next or previous port in
sequence is selected.