Filter
Top Products
53
CHAPTER 5: Operation: On-Screen Display
5.2.2 C
ONFIGURE
S
YSTEM
: M
OUSE
The ServSwitch will also autodetect the mouse type unless you boot the Switch
without a mouse attached, in which it will default to the “PS/2” setting. To change
the mouse type, press [Enter] while “Mouse” is highlighted. An input-selection box
will pop up as shown in Figure 5-3 below.
Figure 5-3. Changing the mouse type.
Use the up- and down-arrow keys to select the desired mouse type and hit [Enter].
Once [Enter] is pressed, the input box disappears and the new setting appears in
the “Mouse” field.
“PS/2 mouse” refers to those IBM PS/2 compatible mice that have a 6-pin mini-
DIN connector and either two or three buttons. They use an interface integrated
onto the CPU’s motherboard, completely independent of the CPU’s serial
interface. Choosing the “PS/2 mouse” option also resets the shared PS/2 mouse
and enables data to be sent from it, even if you didn’t attach the PS/2 mouse to the
ServSwitch until after the Switch had been powered on.
“PS/2 wheel” mice, such as the Microsoft IntelliMouse, are similar to regular
mice, but have a clickable and scrollable wheel control instead of a middle button.
Configure system
Type of mouse auto detected
Keyboard and mouse type
Keyboard PC
Mouse PS/2
PS/2
PS/2 wheel
Serial 2-button
Serial 3-button
Expansion
Maximum computers 8
Expansion units 0
Expansion width 16
Scan settings
Scan time (seconds) 5
Scan mode Off
Power on scan Off
Keyboard typematic
Rate (keys/sec) 20
Delay Fast
Mouse
PS/2