Filter
Top Products
9
Setting up
The T/P (T=TONE, P=PULSE) selector
on the side of the DF60 main unit
must also be switched to the setting you
have selected on the display. This will ensure that
calls can still be made during power failure.
T/P
9 Setting the dial mode
Your DF60 has two dialling modes: TONE and
PULSE, it is pre-set to TONE. This will be the
correct setting for all direct lines and most
switchboards, however for some switchboards
it may need to be set to
PULSE.
To set the Dial mode:
• Press the FUNCTION button until SET
OPTIONS? appears.
• Press the YES button and the display shows:
DIAL MODE?
• Press the YES button, display shows:
DIAL MODE: TONE?
• Press the NO button to change from TONE
to PULSE.
If you are in doubt about the right setting for you,
contact your communications manager.
YES
NO
FUNCTION
RESOLUTION
CONTRAST
POLL
SPEED DIAL
REDIAL
• When the display shows the dialling mode
that is right for you press the YES button,
you will hear a tone confirming your
selection.
• Press the STOP button to return to standby.