Filter
Top Products
TCP/IP CONFIGURATION 10 - 12
You will then get the Local> prompt. Type SET IP ADDRESS
ipaddress, where ipaddress is the desired IP address you wish
to assign to the print server (check with your network manager for the
IP address to use). For example:
Local> SET IP ADDRESS 192.189.207.3
You will now need to set the subnet mask by typing SET IP SUBNET
subnet mask, where subnet mask is the desired subnet mask
you wish to assign to the print server (check with your network
manager for the subnet mask to use). For example:
Local> SET IP SUBNET 255.255.255.0
If you do not have any subnets, use one of the following default
subnet masks:
255.255.255.0 for class C networks
255.255.0.0 for class B networks
255.0.0.0 for class A networks
The leftmost group of digits in your IP address can identify the type
of network you have. The value of this group ranges from 192
through 255 for Class C networks (e.g., 192.189.207.3), 128 through
191 for Class B networks (e.g.,128.10.1.30), and 1 through 127 for
Class A networks (e.g., 13.27.7.1).
If you have a gateway (router), enter its address with the command
SET IP ROUTER routeraddress, where routeraddress is the
desired IP address of the gateway you wish to assign to the print
server. For example:
Local> SET IP ROUTER 192.189.207.1
Type SET IP METHOD STATIC to set the method of IP access
configuration to static.
To verify that you have entered the IP information correctly, type
SHOW IP.
Type EXIT or CTR-D (i.e., hold down the control key and type "D")
to end the remote console session.