Filter
Top Products
TROUBLESHOOTING 11 - 1
11
11
Troubleshooting
Overview
This chapter describes procedures for troubleshooting problems you
may encounter with a Brother print server, it is divided into the
following sections:
1
Installation Problems
2
Intermittent Problems
3
Protocol-Specific Troubleshooting
Installation Problems
If you cannot print over the network, check the following:
1
Make sure that the printer is powered on, is on-line and ready to
print.
Verify that the printer and the configuration are good by printing
the printer settings page. Refer to the Quick Setup Guide. If the
test fails, check:
a
If the LED is not blinking after connected to the network, then
the network firmware settings may be corrupted.
b
In this event, try to restore the factory default settings of the
print server by pressing the Network Test Button on the back
of the printer for more than 5 seconds. Once you have done
that, turn off the printer and then on again. You can check the
settings by printing the printer settings page.