Filter
Top Products
Setup 12
BASIC USE
1
Setup
Initial Settings
Setting the Dialling Mode (Tone/Pulse)
(Not available in New Zealand)
Your machine is initially set to TONE. If you are using a PULSE dial line, you can change the
setting to PULSE by following the steps below.
1
Press
Menu/Set
,
1
,
1
. The screen prompts you to select TONE or PULSE.
2
Use or to select the dialling mode, and press
Menu/Set
when the screen displays the
dialling mode you want.
3
Press
Stop/Exit
.
Setting the Date and Time
The screen displays the date and time you set, whenever the machine is in stand-by mode. It will print
the date and time on every fax you send.
In the event of a power failure, the machine maintains date and time information for about 15 hours
(FAX-1030e), about 9 hours (FAX-1020e).
1
Press
Menu/Set
,
1
,
2
.
2
Enter the two digits of the year, and press
Menu/Set
. “03” is registered as 2003 in the machine.
3
Enter two digits for the month and press
Menu/Set
.
4
Enter two digits for the day and press
Menu/Set
.
5
Enter the time in 24 hour format and press
Menu/Set
.
6
Press
Stop/Exit
.
Although this equipment can use either Pulse or Tone signalling, only the
performance of the Tone signalling is subject to regulatory requirements for correct
operation. It is therefore strongly recommended that the equipment is set to use
the Tone signalling for access to public or private emergency services. The Tone
signalling also provides faster call set up.