Brother HL-600 Printer User Manual


 
USER’S GUIDE
3–4
RESET Switch
Depress and hold the RESET switch until all four lamps are turned on.
The printer is then reset and restored to the user default settings. While
the switch is being depressed, the printer ignores any data. If the switch is
released before all the lamps are turned on, the reset function does not
work. The RESET switch may be able to cancel an error status.
Caution
Remember that the RESET switch clears data from the printer memory
and puts the printer into the sleep mode.
FF/CONT(TEST) Switch
The upper switch on the control panel can work as the Form Feed (FF),
Continue (CONT), or Test print (TEST) switch.
FF/CONT Switch
If the DATA lamp is on, press the FF/CONT switch. The printer prints
any data remaining in the printer memory.
When you use the manual feed slot, the FF/CONT switch is used as the
Form Feed (FF) switch. When you see the MANUAL lamp blinking,
insert a paper all the way into the manual feed slot and press the
FF/CONT switch. After pressing the FF/CONT switch the printer loads
the paper and begins printing. Remember that you need to press this
switch to load every paper manually.
If an error occurs, the printer will usually recover the recoverable errors
such as cover open error automatically. If the error does not clear
automatically, press the FF/CONT switch to clear the error and continue
the operation.
TEST Switch
Keep the TEST switch depressed until all lamps are turned on to execute
the test printing. If the printer is on-line and print data remains in the
printer memory, the printer cannot print a test sample page. If the printer
is off-line and data remains in the printer memory, the printer prints the
remaining data first and then prints a test sample page.