Filter
Top Products
5-85
Confidential
(2) Lift up the CCD Module and Guide shaft and pull the Guide shaft out of the CCD Module.
Fig. 5-101
(3) Remove the Belt support rubber, and then remove the Belt from the CCD module.
(4) Remove the double-faced adhesive tape which is attached between the FFC cable and
CCD module, and disconnect the FFC cable from the CCD module.
Fig. 5-102
Note:
• After disconnecting flat cable(s), check that each cable is not damaged at its end or
short-circuited.
• When connecting flat cable(s), do not insert them at an angle. After insertion, check
that the cables are not at an angle.
2b
2a
Guide shaft
CCD Module
Scanner base
Belt support rubber
3a
3b
Belt
Belt
CCD module
FFC cable