Filter
Top Products
Control panel setup
52
6
Ethernet (wired network only) 6
Ethernet link mode. Auto allows the print server to operate in 100BASE-TX full or half duplex, or in 10BASE-T
full or half duplex mode by auto negotiation.
You can fix the server link mode to 100BASE-TX Full Duplex (100B-FD) or Half Duplex (100B-HD) and
10BASE-T Full Duplex (10B-FD) or Half Duplex (10B-HD). This change is valid after the print server has been
reset (default is Auto).
Note
If you incorrectly set this value, you may not be able to communicate with your print server.
a Press Menu.
b Press a or b to choose Network.
Press OK.
c (MFC-9325CW only)
Press a or b to choose Wired LAN.
Press OK.
d Press a or b to choose Ethernet.
Press OK.
e Press a or b to choose Auto, 100B-FD, 100B-HD, 10B-FD or 10B-HD.
Press OK.
f Press Stop/Exit.
Setup Wizard (MFC-9325CW wireless network only) 6
The Setup Wizard guides you through the wireless network configuration. (For more information, see the
Quick Setup Guide or Using the Setup Wizard from the control panel on page 34.)
WPS/AOSS (MFC-9325CW wireless network only) 6
If your wireless access point supports either Wi-Fi Protected Setup (PBC
1
) or AOSS™ (one-push method),
you can configure the machine easily without a computer. Your Brother machine has the WPS/AOSS menu
on the control panel. This feature automatically detects which mode your access point uses Wi-Fi Protected
Setup or AOSS™. By pushing a button on the wireless access point/router and the machine, you can setup
the wireless network and security settings. See the user’s guide for your wireless access point/router for
instructions on how to access one-push mode. (For more information, see the Quick Setup Guide or Using
the WPS or AOSS control panel menu to configure your machine for a wireless network (Automatic Wireless
mode) on page 31.)
1
Push Button Configuration