Filter
Top Products
Configuring your machine for a wireless network (For MFC-9325CW)
22
3
Wireless network terms and concepts 3
If you want to use your machine in a wireless network you must configure the machine to match the settings
of the existing wireless network. This section provides some of the main terms and concepts of these settings,
which may be helpful when you configure your machine for a wireless network.
SSID (Service Set Identifier) and channels 3
You need to configure the SSID and a channel to specify the wireless network you want to connect to.
SSID
Each wireless network has its own unique network name and it is technically referred to as SSID or ESSID
(Extended Service Set Identifier). The SSID is a 32-byte or less value and is assigned to the access point.
The wireless network devices you want to associate to the wireless network should match the access
point. The access point and wireless network devices regularly send wireless packets (referred to as a
beacon) which has the SSID information. When your wireless network device receives a beacon, you can
identify the wireless network that is close enough for the radio waves to reach your device.
Channels
Wireless networks use channels. Each wireless channel is on a different frequency. There are up to
14 different channels that can be used when using a wireless network. However, in many countries the
number of channels available are restricted. (For more information, see Ethernet wireless network
on page 157.)
Authentication and encryption 3
Most wireless networks use some kind of security settings. These security settings define the authentication
(how the device identifies itself to the network) and encryption (how the data is encrypted as it is sent on the
network). If you do not correctly specify these options when you are configuring your Brother wireless
device, it will not be able to connect to the wireless network. Therefore care must be taken when
configuring these options. Please refer to the information below to see which authentication and encryption
methods your Brother wireless device supports.
Authentication methods 3
The Brother printer supports the following methods:
Open system
Wireless devices are allowed to access the network without any authentication.
Shared key
A secret pre-determined key is shared by all devices that will access the wireless network.
The Brother wireless machine uses the WEP key as the pre-determined key.
WPA-PSK/WPA2-PSK
Enables a Wi-Fi Protected Access Pre-shared key (WPA-PSK/WPA2-PSK), which enables the Brother
wireless machine to associate with access points using TKIP for WPA-PSK or AES for WPA-PSK and
WPA2-PSK (WPA-Personal).