Filter
Top Products
1
2
3
4
5
6
7
8
9
20
z GETTING STARTED
Feeding Tape
Feed & Cut
The Feed & Cut function feeds 0.92" (23mm) of blank tape then cuts the tape.
Hold down the
Shift
key and press the
Preview
key.
"Feed & Cut?" will appear on the LCD display.
Using the or key to select the "Feed & Cut" option and then press either
OK
or
Enter
.
The message "Feeding Tape... Please Wait" appears while the tape is fed, and
then the tape is cut.
Feed Only
This function will advance the tape approximately 0.92" (23 mm) resulting in a blank
label sticking out of the tape cassette. This action is recommended when using Fabric
and Extra Strength Adhesive tapes, which should be cut using scissors.
Hold down the
Shift
key and press the
Preview
key.
"Feed & Cut?" will appear on the LCD display.
Using the or key to select the "Feed Only" option and then press either
OK
or
Enter
key.
The message "Feeding Tape... Please Wait" appears while the tape is fed.
Feeding Tape
• Be sure to feed tape to remove any slack in the tape and ink ribbon after inserting the tape
cassette.
• Do not pull the label coming out of the tape exit slot. Doing so will cause the ink ribbon
to be discharged with the tape.
• Do not block the tape exit slot during printing or when feeding tape. Doing so will cause the
tape to jam.
1
2
To exit or cancel this function press
Escape
.
1
2
To exit or cancel this function press
Escape
.