Filter
Top Products
1
2
3
4
5
6
7
8
9
50
z EDITING A LABEL
Creating a Bar Code Label
Setting Bar Code Parameters
Press the
Setup
key to display the Setup menu, select “Bar Code Setup” using
the or key, and then press the
OK
or
Enter
key
.
The Bar Code Setup screen is displayed.
Select an attribute using the or key, and then set a value for that attribute
using the or key.
Press the
OK
or
Enter
key to apply the settings.
zBar Code Settingsz
1
Pressing
Bar Code
key while holding down the
Shift
key will also allow you to go
to "Bar Code Setup".
2
Characters may not appear below the bar code even when "On" is selected for "Under #",
depending on the tape width being used, the number of lines entered, or the current
character style settings.
3
• New settings are NOT applied if you do not press the
OK
or
Enter
key.
• The "C-Digit" (Check Digit) attribute is only available for the CODE39, I-2/5 and CODABAR
protocols
•Press the
Escape
key to return to the previous step.
•Press the
Space
key to set the selected attribute to the default value.
• Refer to the Bar Code Settings table for a list of all available settings.
Attribute Value
Protocol
CODE39
, CODE128, EAN-8, EAN-13,
GS1-128 (UCC / EAN-128), UPC-A, UPC-E, I-2/5 (ITF),
CODABAR
Width
Small
Large
Under#
(characters printed
below bar code)
On
Off
C.Digit
(check digit)
Off
On
(only available for the CODE39, I-2/5
and CODABAR protocols)