Filter
Top Products
Accessing Local Management
Local Management Supplement 1-5
1.2.2 Screen Format
Since the top part of the screen contains the same type of information (the
name of the screen, the SmartSwitch model number, the firmware
revision, and the BOOT PROM revision), it is not shown in the following
descriptions of the screens. Only the lower portion of the screens is shown
in the following screen descriptions. The name of the screen is shown in
the figure title for each screen. Figure 1-3 shows an example of the fields
in a screen.
Figure 1-3 Example of a Local Management Screen
Firmware Revision: XX.XX.XX
General Configuration
2971_14
BOOTPROM Revision: XX.XX.XX
MAC Address:
IP Address:
Subnet Mask:
Default Gateway:
TFTP Gateway IP Addr:
Device Date:
Device Time:
Screen Refresh Time:
Screen Lockout Time:
Clear NVRAM [NO]
Device Uptime XX D XX H XX M
Device Type: 2H252-25
IP Fragmentation [ENABLED]
Operational Mode: [802.1Q SWITCHING]
Event Message Field
Display Field
Input Fields
Selection Field
Command Fields
Display Fields
2H252-25 LOCAL MANAGEMENT
Event Message Line
RETURNSAVE
03/15/1999
14:23:00
30 sec.
15 min.
EXIT
00-00-ID-00-00-00
0.0.0.0
255.255.0.0
NONE DEFINED
0.0.0.0
See
Note
Note:
This shows the location of the cutaway that is used in most of the screen graphics in this
document. The top portion of the screen is cut away to eliminate repeating the same
information in each graphic.The screen title is contained in the figure title for each screen.