Filter
Top Products
Chapter 1: Changes to Local Management Screens
1-34 Local Management Supplement
1.12.1 Changing Source VLAN and Destination Ports
To add or delete source VLAN and destination port entries and set the
Frame Format, proceed as follows:
1. Use the arrow keys to highlight the Source VLAN field near the
bottom of the screen.
2. Type in the VLAN ID number of the source VLAN to be configured.
3. Use the arrow keys to highlight the Destination Port field near the
bottom of the screen.
4. Use the SPACE bar or BACKSPACE to step to the appropriate port
number for the destination port.
5. Use the arrow keys to highlight the Frame Format field near the
bottom of the screen.
6. Use the SPACE bar or BACKSPACE to step to the appropriate frame
format setting (RECEIVED, TAGGED, or UNTAGGED) for the
selected Destination Port.
7. Use the arrow keys to highlight the Status field.
8. Use the SPACE bar to select either the ADD or DEL (delete) option.
Press ENTER. This adds or deletes the selections for the Source
VLAN, Destination Port, and Frame Format made in steps 1
through 6 and also updates the screen.
NOTE
Multiple VLANs may be assigned to a destination port.
TIP
If more than one VLAN is being redirected, repeat steps 1
through 8 for each additional setting. Then go to step 9 to save
all the new settings at once.
If an entry is to be changed, delete the entry, save the screen,
then recreate the entry with its new settings.
Any combination, up to 128, of port redirect instances
(configured on the Port Redirect Configuration screen) and/or
VLAN redirect instances (configured on the VLAN Redirect
Configuration screen) can be configured.