Filter
Top Products
Setting the Mode Switch
6H122-08 User’s Guide C-3
• After changing the position of switch 6 and restarting the module, the
6H122-08 requests a new image download until they either receive a
new image or the RESET button on the front panel is pressed. When
the RESET button is pressed, the 6H122-08 continues trying to contact
a BootP server, but will time out in approximately one minute. If the
module times out, the image is downloaded from its FLASH memory.
• Switch 7 – Clear NVRAM. Changing the position of this switch resets
NVRAM on the next power up. ALL user entered parameters, such as
IP addresses, subnet masks, SNMP traps, and switching functions are
restored to their factory default settings.
• Switch 8 – Reset Password/Community Strings. Changing the position
of this switch clears only the user-entered passwords stored in
NVRAM, and restores the default passwords. Once the 6H122-08
resets, the passwords can either be reentered or the default passwords
(Public and ENTER) may be used.
NOTE
Do not change the position of switch 8 unless it is necessary to
reset the module super-user configured passwords to their
factory default settings.