Filter
Top Products
SNMP Community Names Screen
6H122-08 User’s Guide 5-55
5.15.14 Enabling/Disabling IP Fragmentation
To enable or disable IP fragmentation, proceed as follows:
1. Use the arrow keys to highlight the IP Fragmentation field.
2. Press the SPACE bar to choose either ENABLED or DISABLED.
3. Use the arrow keys to highlight the SAVE command.
4. Press ENTER. The Event Message Line at the top of the screen
displays “SAVED OK”.
5.16 SNMP COMMUNITY NAMES SCREEN
The SNMP Community Names menu item allows the user to set
Local/Remote Management community names. Community names act as
passwords to Local/Remote Management and are agents of security
access to the 6H122-08. Access to the 6H122-08 is controlled by enacting
any of three different levels of security authorization (read-only,
read-write, and super-user).
!
CAUTION
If the 6H122-08 is being bridged to an FDDI ring IP
Fragmentation should be enabled. If IP Fragmentation is
disabled, all FDDI frames that exceed the maximum Ethernet
frame size will be discarded.
NOTE
If the 6C105 has been assigned community names, it is not
necessary to assign community names to the individual
modules installed in the chassis unless the user wishes to limit
access to 6C105 chassis screens by assigning different
community names to the module. When this is done access is
limited to the screens specific to the module the terminal is
attached to and the CHASSIS menu item of the Main Menu
screen will not appear.
Super-User access gives the user full management privileges,
allows existing passwords to be changed, as well as all
modifiable MIB objects.