Filter
Top Products
Installing the RoamAbout Access Point 3-3
Installing the AP into a MultiSwitch 900 or DEChub 90
Installing the AP into a MultiSwitch 900 or DEChub 90
This section describes how to install the AP in a MultiSwitch 900 or DEChub 90.
Removing the Back Cover
If there is a cover on the back of the AP, you must remove it before inserting the AP
into the backplane. Perform the following steps to remove the back cover:
Step Action
1 Lift up the latch on the back cover by inserting a flat-blade screwdriver
into the top mounting hole.
2 With the latch up, pull the top of the back cover away, pivoting at the
bottom of the AP.
LKG-6722-921-01