Filter
Top Products
Installing the RoamAbout Access Point 3-5
Installing the AP
Installing the AP
Perform the following procedure to install the AP as a standalone module. Also, you
may need to perform steps 4 and 5 after installing the AP in a DECHub 90 or
MultiSwitch 900.
Step Action
1 Place the AP in the previously defined location. Site requirements are
defined in Chapter 2.
2 Connect the AP to the wired network using either the 10BaseT or
ThinWire connector, as follows:
To Connect to ThinWire Network –– Connect a ThinWire cable,
T-connector, and terminator to the BNC connector on the AP. Note that
instead of a terminator, the other side of the T-connector can be cabled
to another device in the LAN.
50-ohm
Terminator
T-Connector
1
2
R
o
a
m
A
b
o
u
t
LKG-8685-931-01
Access Point