Filter
Top Products
Configuring the RoamAbout Access Point 4-19
Configuring the AP for SNMP Management
Set SNMP Trap Addresses
To have the AP send SNMP traps, you need to enter the IP address of the device where
the trap is to be sent. A trap is a defined event or condition detected by the RoamAbout
Access Point SNMP agent.
To enter an SNMP trap address using the console port:
1) At the RoamAbout Installation Menu, choose Add SNMP Trap Addresses.
2) Enter the SNMP trap address.
Note: To not change the existing value, press Return to go back to the previous
menu.
To delete an existing trap address using the console port:
1) At the RoamAbout Installation Menu, choose Delete SNMP Trap Addresses.
2) Enter the existing SNMP trap address that you wish to delete.
Note: To not change the existing value, press Return to go back to the previous
menu.