Filter
Top Products
Chapter 2 Preparation Before Use
24
◆ Setting the SCSI ID
Set the SCSI ID using the DIP (Dual Inline Package) switch located on the left
side of the SCSI connector.
Push the DIP switches down to turn them ON, and push them up to turn them
OFF. Refer to the following table to set the SCSI ID using the DIP switches.
DIP Switches
●The SCSI ID default is set to 2. Be careful not to set the same SCSI ID as other SCSI
devices that are mounted internally or connected to the computer.
●Disable the terminator on any SCSI device that might be connected between the
scanner and the computer.
Important
SCSI Connections
Turn off the computer and then connect the scanner and the computer with the
SCSI cable.
Be sure to turn off the power to the scanner and the computer before connecting the
SCSI cable.
SCSI Connector
Half-pitch 50-pin
(pin type)
SCSI Cable
Important
USB Connector
(cannot be connected)