Filter
Top Products
6. Press ▲ or ▼ to select Adjust Length, and then press the OK button.
7. Press ▲ or ▼ to select AdjustmentPrint or Change Settings, and then press the OK button.
When you select AdjustmentPrint, a test pattern is printed for you to measure the scale and calculate the discrepan-
cy. The scale bar shows Millimeter in 50 mm increments and Inch in 1-inch increments.
Note
• A test pattern is printed in black when you choose A:High or in magenta if you choose B:Standard/
Draft.
• To cancel printing the test pattern for adjustment, hold down the Stop button. When "Stop print-
ing?" is displayed, press ▲ or ▼ to select "Yes", and then press the OK button.
8. Press ▲ or ▼ to enter the amount of discrepancy, and then press the OK button.
If the scale is shorter than the actual size, use a positive setting value. If it is longer, use a negative value.
The feed amount can be adjusted in 0.02% increments.
Adjusting Color on the Trailing Edge of Sheets
If printed sheets are affected by banding in different colors by the trailing edge (about 20–30 mm (0.8–1.2 in) from the
edge), try adjusting the feed amount of the trailing edge of sheets.
Note
• For banding in different colors over the entire printed area of sheets or rolls (not only at the trailing edge of
sheets), try adjusting the overall feed amount. (See "Automatic Banding Adjustment (Adj. Quality).")
→P.772
• This adjustment is only possible when feeding paper from the Top Paper Feed Slot that can be set up with a
margin on the trailing edge of 3 mm (0.12 in). Paper that does not allow a margin of 3 mm on the trailing
edge is automatically ejected, and the adjustment is not available.
1. Load one sheet of unused paper of at least A4/Letter size.
Note
• Always make sure the loaded paper matches the type of paper specified in the settings. Adjustment
cannot be completed correctly unless the loaded paper matches the settings.
• We recommend using the type of paper you use most often for adjustment.
Adjustments for Better Print Quality
>
Adjusting the feed amount
>
Adjusting Color on the Trailing Edge of Sheets iPF6300
7
778