Filter
Top Products
19
BASIC OPERATION
TURNING ON THE PROJECTOR
TURNING OFF THE PROJECTOR
Press the POWER ON-OFF button on the Top Control or on the
Remote Control Unit, and the message “Power off?” appears on
a screen.
Press the POWER ON-OFF button again to turn off the
projector. The LAMP Indicator lights bright and the READY
Indicator turns off. After the projector is turned off, the Cooling
Fans operate (for 90 seconds).
1
2
TO MAINTAIN THE LIFE OF LAMP, ONCE YOU TURN
PROJECTOR ON, WAIT AT LEAST 5 MINUTES BEFORE
TURNING IT OFF.
DO NOT DISCONNECT AC POWER CORD BEFORE
READY INDICATOR LIGHTS GREEN.
TURNING ON / OFF THE PROJECTOR
When the WARNING TEMP. Indicator flashes red, the projector is automatically turned off. Turn the projector on with the
POWER ON-OFF button after the READY indicator lights green.
When the WARNING TEMP. Indicator continues to flash, refer to the section “MAINTENANCE” on page 41 and proper
maintenance should be taken.
3
When the projector has cooled down, the READY Indicator lights
green again.
Power off?
Message disappears after 4 seconds.
When the Power management function is ON, the projector detects signal interruption and turns off the Projection Lamp
automatically. Refer to the menu item “Power management” on page 37.
NOTE : The projector cannot be turned on during cooling period with
the READY Indicator off. You can turn it on again after the
READY Indicator lights green.
note on operation
Connect the AC Power Cord into an AC outlet. The LAMP
Indicator lights red, and the READY Indicator lights green.
Press the POWER ON-OFF button on the Top Control or on the
Remote Control Unit to ON. The LAMP Indicator dims, and the
Cooling Fans start to operate. The Preparation Display appears
on the screen and the count-down starts.
2
3
1
Complete all peripheral connections (with Computer, VCR, etc.)
before turning on the projector. (Refer to the “CONNECTING
THE PROJECTOR” on page 11~13.)
26
The Preparation Display disappears after 30 seconds.
NOTE : When the On start function is ON, this projector is turned on
automatically by connecting the AC Power Cord to an AC
outlet. (Refer to the menu item “On start” on page 37.)
4
The image level that was selected last and the Lamp mode
status appear for 4 seconds, and the signal from PC or Video
source appears.
*Refer to page 37 for the Lamp mode.
Lamp mode