Filter
Top Products
31
VIDEO INPUT
SELECTING THE INPUT SOURCE
MENU OPERATION
DIRECT OPERATION
Choose Video by pressing the INPUT button on the Top Control or on
the Remote Control Unit.
If the projector cannot reproduce a proper video source, select correct
input source through the “MENU OPERATION” (see below).
Press the MENU button and the ON-SCREEN MENU will
appear. Press the POINT LEFT/RIGHT button to move the red
frame pointer to the INPUT Menu icon.
Press the POINT DOWN button to move the red arrow pointer to
Video and then press the SET button. The Source Select Menu
will appear.
1
2
Move the pointer to
Video and press the
SET button.
VIDEO
Move the pointer to the source and press the SET
button.
Source Select Menu (VIDEO)
INPUT MENU
Move the pointer to the source that you want to select and then
press the SET button.
3
When selecting Auto, the projector automatically detects
the incoming video signal, and adjusts itself to optimize
its performance. The projector selects the connection in
the following order:
1st Y-Pb/Cb-Pr/Cr
2nd S-VIDEO
3rd VIDEO
Y-Pb/Cb-Pr/Cr has priority over S-VIDEO. S-VIDEO has
priority over VIDEO.
Auto
When the video input signal is connected to VIDEO/Y
jack, select Video.
Video
When the video input signal is connected to S-VIDEO
jack, select S-Video.
S-Video
When the video input signal is connected to
VIDEO/Y-Pb/Cb-Pr/Cr jacks, select Y, Pb/Cb, Pr/Cr.
Y,Pb/Cb,Pr/Cr
INPUT button
Computer 1
Video
Computer 2
✽
✽
Computer 1 is not displayed when RGB IN 1/ OUT
terminal is used as MONITOR OUT.
✽
RGB Scart Input
To select RGB Scart 21-Pin video input through RGB IN 1 / OUT
terminal, see the “COMPUTER INPUT (RGB Scart 21-Pin Video
Input)” on page 22.
Computer 1 is not displayed when RGB IN 1/ OUT
terminal is used as MONITOR OUT.