Filter
Top Products
25
COMPUTER INPUT
PC ADJUSTMENT
AUTO PC ADJUSTMENT
The Auto PC Adjustment function automatically adjusts Fine sync, Total dots, Horizontal and Vertical picture position to
conform to your computer. The Auto PC Adjustment function can be operated as follows.
Press the MENU button and the ON-SCREEN MENU will
appear. Press the POINT LEFT/RIGHT button to move the red
frame pointer to the PC ADJUST Menu icon.
1
2
Press the POINT DOWN button to move the red frame pointer to
the AUTO PC Adj. icon and then press the SET button twice.
This Auto PC Adjustment can also be executed by pressing the
AUTO PC ADJ. button on the Remote Control Unit.
Move the pointer to the AUTO PC Adj. icon
and press the SET button.
PC ADJUST MENU
Auto PC Adj.
Store adjustment parameters.
Adjustment parameters from Auto PC Adjustment can be memorized
in this projector. Once parameters are memorized, setting can be
done just by selecting Mode in the PC SYSTEM Menu (P23). Refer to
step 3 of the “MANUAL PC ADJUSTMENT” section (P27).
NOTE
● The PC ADJUST Menu cannot be operated when the input signal is
digital or RGB is selected in the PC SYSTEM Menu (P23).
● Fine sync, Total dots, Horizontal, and Vertical of some computers
cannot be fully adjusted with this Auto PC Adjustment function.
When the image is not provided properly through this function,
manual adjustments are required. (Refer to page 26, 27.)
● The Auto PC Adjustment function cannot be operated when “720p
(HDTV),” “1035i (HDTV),” or “1080i (HDTV)” is selected in the PC
SYSTEM Menu (P23).
PC ADJUST Menu icon