Filter
Top Products
Chapter 1 Introducing the Cisco Wide Area Application Engine
Hardware Features
1-12
Cisco Wide Area Application Engine 512 and 612 Hardware Installation Guide
OL-9137-02
To access the Ethernet port, connect a Category 3, 4, or 5 unshielded twisted-pair
(UTP) cable to the RJ-45 connector on the back of the device.
Note The 100BASE-TX/1000BASE-TX Ethernet standard requires that the cabling in
the network be Category 5 or higher.
Figure 1-8 shows the pin number assignments for the Ethernet RJ-45 port.
Figure 1-8 Ethernet Port Connector
Serial Port Connector
The WAE appliance has one standard serial port connector located on the back of
the device.
Figure 1-9 shows the pin number assignments for the 9-pin, male D-shell serial
port connector on the back of the device. These pin number assignments conform
to the industry standard for RS-232 communications.
Figure 1-9 Serial Port Connector
1
8
Link LED
(green)
Activity LED
(green)
83195
1
5
69
83193