Filter
Top Products
3-15
Cisco Wide Area Application Engine 512 and 612 Hardware Installation Guide
OL-9137-02
Chapter 3 Installing the Cisco Wide Area Application Engine
Connecting Power and Booting the System
Connecting Power and Booting the System
To connect power to the device, follow these steps:
Step 1 Review the information in the “Safety Warnings” section on page 2-1.
Step 2 Plug the AC power cord into the power cord receptacle at the rear of the device.
(See
Figure 3-12.)
Step 3 Connect the other end of the power cord to a power source at your installation site.
Step 4 Power up all externally connected devices.
Step 5 Press the power control button on the front of the device.
The system should begin booting. Once the operating system boots, you are ready
to initialize the basic software configuration. (See the
“Related Documentation”
section on page xi for a list of software configuration documents.)
Note While the device is powering up, the power LED on the front of the
chassis is green.
Checking the LEDs
When the device is up and running, observe the front panel LEDs. To verify that
your system is operating properly, see
the “LED Indicators” section on page 1-7.
Removing or Replacing a Cisco Wide Area
Application Engine
Warning
Before working on a chassis or working near power supplies, unplug the power
cord on AC units.
Statement 246