Filter
Top Products
BXM T3/E3, 155, and 622 6-33
Command Line Interface Examples
An example of the upln command for UNI port access on a BXM card follows:
pubsbpx1 TN YourID:1 BPX 15 9.1 Jan. 11 1998 02:18 GMT
Line Type Current Line Alarm Status
3.1 OC3 Clear - OK
3.2 OC3 Clear - OK
3.3 OC3 Clear - OK
5.1 T3 Clear - OK
5.2 T3 Clear - OK
Last Command: upln 3.3
Next Command:
Note The initial command to up a trunk (uptrk) or to up a line (upln) on the BXM card configures
all the ports of the card to be either trunks or lines (UNI port access). Following the upln command
at each port, the upport command is used to activate a port for UNI access.
An example of the cnfln command follows:
pubsbpx1 TN YourID:1 BPX 15 9.1 Jan. 11 1998 02:24 GMT
LN 3.3 Config OC3 [353208cps] BXM slot: 3
Loop clock: No Idle code: 7F hex
Line framing: --
coding: --
CRC: --
recv impedance: --
E1 signalling: --
encoding: -- cable type: --
T1 signalling: -- length: --
HCS Masking: Yes
Payload Scramble: Yes
56KBS Bit Pos: -- Frame Scramble: Yes
pct fast modem: -- Cell Framing: STS-3C
This Command: cnfln 3.3
Loop clock (N):