Filter
Top Products
4-30
Cisco Carrier Sensitive Routing User Guide
Chapter4 CSR GUI Functionalities
Updating Active Datasets
Note Alternatively, you can delete an attribute by clicking Delete when you are in the dialog box
for modifying the attribute.
Creating, Modifying, and Deleting Match Patterns
This section describes the steps to create, modify, and delete Match Patterns.
Creating Match Patterns
Step 1 In the Active Dataset tab in the CSR window, click the down arrow in the Selection box, then select
Match Patterns from the pull-down menu.
Step 2 Click New. The following New Pattern dialog box appears (Figure4-30 “Dialog Box for New Pattern
in Active Dataset”):
Figure4-30 Dialog Box for New Pattern in Active Dataset
The Pattern Key on this screen is the primary key of this pattern in the Match Patterns Table. When a
new pattern is being created, “%%%%” is displayed.
Step 3 In the Pattern box, enter the match pattern that a DNIS is to mapped to.
This entry can include 0-9, A-F, *, and period (.).
Step 4 In the Route box, enter the route that applies to this pattern.
Step 5 Click Add to add this pattern, or click Cancel to exit.