Filter
Top Products
4-35
Cisco Carrier Sensitive Routing User Guide
Chapter4 CSR GUI Functionalities
Updating Active Datasets
Creating, Modifying, and Deleting Rules
This section describes the steps to create, modify and delete rules.
Creating Rules
Step 1 In the Active Dataset tab in the CSR window, click the down arrow in the Selection box, then select
Rules from the pull-down menu.
Step 2 Click New.
The New Rule dialog box appears (Figure4-35 “Dialog Box for New Rule in Active Dataset”):
Figure4-35 Dialog Box for New Rule in Active Dataset
The key shown on the screen is the primary key of this rule in the Rules table. When a new rule is being
created, “%%%%” is displayed.
Step 3 In the Name box, enter the name of the rule. The range is 1 to 64 characters.
Step 4 In the Min QoS box, enter the lowest QoS level associated with this rule. The range is 1 to 9.
Step 5 Click the checkbox to the left of Is Default Rule to select this rule as the default rule.
Note One rule must be made the default rule for the provisioned data to be valid.
Step 6 In the Rejection Rules (Ingress) area, check the checkbox next to the rule that you want to activate as a
rejection rule as follows: