Filter
Top Products
C-1
Cisco IE 2000 Switch Hardware Installation Guide
OL-25818-04
APPENDIX
C
Configuring the Switch with the CLI-Based Setup
Program
This appendix provides a command-line interface (CLI)-based setup procedure for a switch. For
information about setting up the switch by using Express Setup, see the Cisco IE 2000 Switch Getting
Started Guide.
Before connecting the switch to a power source, review the safety warnings in Warnings, page 2-1
For installation procedures, see Chapter 2, “Switch Installation.”
Accessing the CLI Through the Console Port
You can enter Cisco IOS commands and parameters through the CLI. Use one of these options to access
the CLI:
• RJ-45 Console Port
• USB Mini-Type B Console Port
Removing the USB Mini-Type B Console Port Cover
To remove the cover from the USB mini-type B console port:
Step 1 Use a Philips screwdriver to loosen the captive screw on the USB mini-type B console port cover. See
See Figure C-1. Remove the screw and take off the cover.