Filter
Top Products
2-47
Cisco IE 2000 Switch Hardware Installation Guide
OL-25818-04
Chapter 2 Switch Installation
Verifying Switch Operation
Figure 2-31 Connecting to a Dual-Purpose Port
Step 2 Connect the other end of the cable to the other device.
By default, the switch detects whether an RJ-45 connector or SFP module is connected to a dual-purpose
port and configures the port accordingly. You can change this setting and configure the port to recognize
only an RJ-45 connector or only an SFP module by using the media type interface configuration
command. For more information, see the Cisco IE 2000 Switch Command Reference.
Verifying Switch Operation
Before installing the switch in its final location, power on the switch, and verify that the switch powers
up in boot fast style. The boot fast sequence allows the switch to boot up in less than 60 seconds.
Where to Go Next
If the default configuration is satisfactory, the switch does not need further configuration. You can use
any of these management options to change the default configuration:
• Start Device Manager, which is in the switch memory, to manage individual and standalone
switches. This is an easy-to-use web interface that offers quick configuration and monitoring. You
can access Device Manager from anywhere in your network through a web browser. For more
information, see the Getting Started Guide and the Device Manager online help.
1 LC connector (optical) 2 RJ-45 connector (copper)
16TC
±12/24/48
0.5-3.0A
331562
2
1