Filter
Top Products
2-4
Cisco Connected Grid Ethernet Switch Module Interface Card Getting Started Guide
OL-23421-02
Chapter 2 Installation
Installation
Step 4 Grasp the handles and carefully slide the module into the card guide, then push with both hands until the
module is flush against the router chassis (see Figure 2-3).
Figure 2-3 Installing the Switch Module in the CGR 2010 Router
Step 5
Tighten the screws:
a. Tighten the lower flathead screw to the bottom center hole.
b. Tighten the second panhead screw to the top center hole.
Step 6 Tighten the three captive screws on the front of the switch module:
a. Tighten the captive screw on the lower left of the module.
b. Tighten the single captive screw on the right side of the module.
c. Finally, tighten the captive screw on the upper left of the module.
The switch module is now successfully installed in the router (see Figure 2-4).
237927