Filter
Top Products
3-3
Cisco Connected Grid Ethernet Switch Module Interface Card Getting Started Guide
OL-23421-02
Chapter 3 Express Setup
Express Setup
Step 6 Select one of the following:
• For the Copper Model (GRWIC-D-ES-2S-8PC), connect a Cat 5 or 6 cable to the blinking
10/100BASE-T port, and the plug the other end to the Ethernet port on your computer
• For the SFP Fiber Model (GRWIC-D-ES-6S), connect a Category 5 or Category 6 cable to the
100/1000BASE-T port of the dual-purpose port (GE0/1), and then plug the other end to the Ethernet
plug on your computer
Wait until the port LEDs on the switch module and your computer are either green or blinking green
(indicates successful connection).
Tip If the port LEDs are not green after 30 seconds, verify you are using Cat 5 or 6 cable and that
the cable is not damaged. Make sure the other devices are turned on. You can also verify the
connection by pinging IP address 169.250.0.1.
Follow these steps to configure the switch module:
Step 1 Open a web browser and enter the switch module IP address.
Step 2 Enter cisco as the default username and password.
Figure 3-2 Express Setup Window
Tip If you cannot access Express Setup, verify that all pop-up blockers or proxy settings are
disabled, and that any wireless client on your computer are disabled.