Filter
Top Products
2-11
Cisco UCS C22 Server Installation and Service Guide
OL-26646-01
Chapter 2 Installing the Server
Initial Server Setup
Step 14 Press F5 to refresh the settings you made. You might have to wait about 45 seconds until the new settings
appear and the message,
Network settings configured is displayed before you reboot the server in the
next step.
Step 15 Press F10 to save your settings and reboot the server.
Note If you chose to enable DHCP, the dynamically assigned IP and MAC addresses are displayed on
the console screen during bootup.
Step 16 Connect to the Cisco IMC interface for server management. Connect Ethernet cables from your LAN to
the server, using the ports that you selected by your NIC Mode setting in Step 4. The Active-active and
Active-passive NIC redundancy settings require you to connect to two ports.
Step 17 Use a browser and the IP address of the Cisco IMC to connect to the Cisco IMC Setup Utility. The IP
address is based upon the settings that you made in Step 4 (either a static address or the address assigned
by your DHCP server).
Note The default user name for the server is admin. The default password is password.
To manage the server, see the Cisco UCS C-Series Rack-Mount Server Configuration Guide or the Cisco
UCS C-Series Rack-Mount Server CLI Configuration Guide for instructions on using those interfaces.
The links to these documents are in the C-Series documentation roadmap:
http://www.cisco.com/go/unifiedcomputing/c-series-doc