Filter
Top Products
3-36
Cisco UCS C22 Server Installation and Service Guide
OL-26646-01
Chapter 3 Maintaining the Server
Installing or Replacing Server Components
h. If the card that you replaced was a RAID controller, continue with Restoring RAID Configuration
After Replacing a RAID Controller, page C-22.
Special Considerations for Cisco UCS Virtual Interface Cards
Table 3-8 describes the requirements for the supported Cisco UCS virtual interface cards (VICs).
Note The Cisco UCS VIC P81E is not supported in the C22 Large Form Factor version of the server.
RAID Controller Card Cable Routing
If the PCIe card that you are installing or replacing is a RAID controller card, see RAID Controller
Considerations, page C-1 for required cables and cable routing guidelines.
See also Replacing the SuperCap Power Module (RAID Backup Unit), page 3-41 for instructions on
installing a RAID backup unit for a RAID controller card.
Table 3-8 Cisco UCS C22 Requirements for Virtual Interface Cards
Virtual Interface Card
(VIC)
Number of
VICs
Supported
in Server
Slots That
Support
VICs
1
1. See PCIe Slots, page 3-34.
Primary Slot For
UCS Integration
or Cisco Card
NIC Mode
Minimum
Cisco IMC
Firmware
Minimum VIC
Firmware For
Use With UCS
Integration
Minimum Nexus
OS on an Upstream
Nexus Fabric
Interconnect
Cisco UCS VIC P81E
2
N2XX-ACPCI01
2. See note below.
1 PCIE 1 PCIE 1 1.4(5) 2.0(2) 5.0
Cisco UCS VIC 1225
UCSC-PCIE-CSC-02
1 PCIE 1 PCIE 1 1.4(6) 2.1(0) 5.0
Cisco UCS VIC1225T
UCSC-PCIE-C10T-02
1 PCIE 1 PCIE 1
3
3. The Cisco UCS VIC1225T is not supported for UCS integration at this time.
1.5(1) 2.1(1) 5.0
Cisco UCS VIC1285
UCSC-PCIE-C40Q-02
1 PCIE 1 PCIE 1 1.5(4) 2.2(1b) 5.0