Filter
Top Products
5–4 iPAQ Connection Point CP-2E User Guide
Advanced Setup Icons
Timezone Setup
For a full discussion of the Timezone setup, please refer to Chapter 2.
Internet
For a full discussion of the Internet Connection method setup, please refer
to Chapter 2.
LAN
The LAN page allows you to adjust the TCP/IP settings of the Connection
Point CP-2E.
The default network IP address of the Connection Point CP-2E is
192.168.1.1. This IP address is also the default gateway and DNS server
that local clients use to access the Internet, leaving 253 IP addresses to be
assigned to LAN computers by the DHCP server.
You can change the IP address of the LAN interface on the Connection
Point CP-2E. You can also change the subnet mask, but if you do, you
must ensure that the new subnet includes the addresses your DHCP server
uses.
Note: If you choose a LAN interface subnet that doesn't include the current range
of the DHCP server, the DHCP server is automatically disabled. The current
DHCP server range is listed at the bottom of the page (DHCP Start Address
and DHCP End Address).
MAC Address: Displays the Ethernet Media Access Control (MAC)
address of the LAN interface on the Connection Point CP-2E. It is
expressed in six 2-digit hexadecimal number pairs (set at the factory)
and cannot be changed.
LAN IP Address: Displays the current IP address assigned to the
LAN interface on the Connection Point CP-2E. The IP address is
written in dotted decimal notation (four octets separated by decimal
points). This IP address serves as the DNS server/relay and the
default gateway for computers on the local network.