Filter
Top Products
Advanced Setup Icons
iPAQ Connection Point CP-2E User Guide 5–13
3. Type the IP address of the public network device to be filtered out into
the Destination IP field.
4. Click Apply. The Connection Point CP-2E must be rebooted for
applied changes to take effect.
5. Click OK. You can reboot the Connection Point CP-2E at any time by
clicking the Reboot button at the left.
Adding Port Rules
1. Click the Port Rules link. The Port Rules page is displayed.
2. Click Add. The Add Port Rules page is displayed.
3. Select the protocol (or application) from the Protocol pulldown
menu. If you select a pre-defined protocol from the list, the
corresponding port number and service type are automatically set.
The Port edit box is disabled unless you choose the User-Defined
option at the bottom of the protocol list. This allows you to enter a
port number that is not on the pre-defined protocol list.