Filter
Top Products
5–8 iPAQ Connection Point CP-2E User Guide
Advanced Setup Icons
3. Select Manual or Network Computer List in the DMZ Host
Selection Method field.
4. If you selected Manual in Step 3, enter the IP address of the DMZ PC
in the DMZ Host (Manual Entry) field.
5. If you selected Network Computer List in Step 3, click the radial
button next to the computer name of the DMZ PC in the Network
Computer List field.
6. Click Apply. The Connection Point CP-2E must be rebooted for
applied changes to take effect.
7. Click OK. You can reboot the Connection Point CP-2E at any time by
clicking the Reboot button at the left.
Virtual Server
Virtual servers allow you to redirect incoming data on a specific port to a
server on the local network. You can configure multiple servers on your
local network, such as HTTP and FTP servers, and make them accessible
to users on the Internet without fully removing them from behind the
Connection Point CP-2E firewall.
Server Status: Displays the status of the virtual server, either enabled
or disabled.
Global Port: Displays the TCP or UDP port number that is visible to
external users on the Internet. This is also known as the external port
number. The port is mapped to a computer on your LAN.
Local IP: Displays the IP address on the local network to which the
incoming data from the Internet should be redirected.
Local Port: Displays the IP port number to which incoming data is
redirected. This port is mapped to the global port.
Protocol: Displays the protocol used on the specified port.
Comment: Displays a user-defined description of the virtual server.
This field is optional.