Filter
Top Products
5–22 iPAQ Connection Point CP-2E User Guide
Advanced Setup Icons
3. Type the destination IP address to which you wish to assign a
specified route into the Network Address field.
4. Type the subnet mask associated with the destination IP address into
the Subnet Mask field. This determines which part of the destination
IP address is the network portion, and which is the host portion.
5. Type the IP address of the gateway device that is used to contact the
destination IP address into the Gateway field. If the destination
address is on the LAN, this gateway IP address must be in the range
of the assigned DHCP addresses for the LAN.
6. Select the LAN Ethernet or WAN from the Interface pulldown menu.
If you are connecting to a local subnet, select LAN. If you are
connecting to another computer through the internet, select WAN.
7. Click Apply. The Connection Point CP-2E must be rebooted for
applied changes to take effect.
8. Click OK. You can reboot the Connection Point CP-2E at any time by
clicking the Reboot button at the left.