Filter
Top Products
Advanced Setup Icons
iPAQ Connection Point CP-2E User Guide 5–21
Static Routing Table
The Static Routing Table defines pre-determined routes that Internet data
packets use when they are addressed to specific destination computers.
These entries are based on the IP address of the destination computer. It
may be necessary to define static routes when your Connection Point
CP-2E is connected to more than one local network, or when a site on the
Internet cannot be reached because too many hops are needed to route the
IP packet dynamically.
Adding a Static Route
1. Click the Static Routing Table link at the left. The Static Routing
Table page is displayed.
2. Click Add. The Add Static Routing Table page is displayed.