. . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
E-1
Compaq Keyboard/Monitor/Mouse Switch Box User Guide
Writer: Kristi Wishon Project: Power Cord Set Requirements Comments:
File Name:L-ape.doc Last Saved On:9/6/96 3:19 PM
Appendix E
Power Cord Set
Requirements
The voltage select switch feature of your switch box permits it to operate from
any line voltage between 100-120 or 200-240 volts AC.
The power cord set (appliance coupler, flexible cord, and wall plug) you
received with your switch box meets the requirements for use in the country
where you purchased your equipment.
Power cord sets for use in other countries must meet the requirements of the
country where you use the switch box. For more information on power cord
set requirements, contact your Authorized Compaq Dealer.
General Requirements
The requirements listed below are applicable to all countries:
■
The length of the power cord must be at least 6.00 feet (1.8 m) and a
maximum of 9.75 feet (3.0 m).
■
All power cord sets must be approved by an acceptable accredited
agency responsible for evaluation in the country where the power cord
will be used.
■
The power cord set must have a minimum current capacity of 10A and
a nominal voltage rating of 125 or 250 volts AC, as required by each
country’s power system.
■
The appliance coupler must meet the mechanical configuration of an
EN 60320/IEC 329 Standard Sheet C7 connector for mating with the
appliance inlet on the switch box.