Filter
Top Products
General Features
30 QuickScan
®
L
FN1 Substitution Values
The Wedge and USB HID Keyboard hosts support an FN1 substitution feature. When
enabled, any FN1 character (0x1b) in an EAN128 bar code is substituted with a value.
This value defaults to 7013 (Enter Key).
To select an FN1 substitution value via bar code menus:
1. Scan the bar code below.
2. Look up the keystroke desired for FN1 Substitution inAppendix F, ASCII Character
Sets for the currently installed host interface.
3. Enter the 4-digit substitution value by scanning each digit in Appendix E, Keypad.
To correct an error or change the selection, scan Cancel.
To enable FN1 substitution for keyboard wedge, scan the Enable FN1 Substitution
on page 63.
To enable FN1 Substitution for USB HID keyboard, scan the Enable FN1 Substitu-
tion on page 82.
Transmit “No Read” Message
Scan a bar code below to select whether or not to transmit a No Read message. When
enabled, the characters NR are transmitted when a bar code is not decoded. When dis-
abled, if a bar code does not decode, nothing is sent to the host.
*Set FN1 Substitution Value
Enable No Read
*Disable No Read