Filter
Top Products
RS-232 Parameter Defaults
Product Reference Guide 33
RS-232 Parameter Defaults
Table 5 lists the defaults for RS-232 host parameters. If any option needs to be changed,
scan the appropriate bar code(s) provided in the Parameter Descriptions section begin-
ning on page 33.
RS-232 Host Parameters
Various RS-232 hosts are set up with their own parameter default settings (Table 6). Se-
lecting the ICL, Fujitsu, Wincor-Nixdorf Mode A, Wincor-Nixdorf Mode B, Olivetti,
Omron, or terminal sets the defaults listed in Table 6.
Selecting the ICL, Fujitsu, Wincor-Nixdorf Mode A, Wincor-Nixdorf Mode B, OPOS
terminal enables the transmission of code ID characters listed in Table 7 on page 34.
These code ID characters are not programmable and are separate from the Transmit
Code ID feature. The Transmit Code ID feature should not be enabled for these termi-
nals.
NOTE
See
Appendix B, Standard Defaults for all user preferences, hosts, symbolo-
gies, and miscellaneous default parameters.
Table 5. RS-232 Defaults
Parameter Default Page Number
RS-232 Host Parameters
RS-232 Host Types Standard
36
Baud Rate 9600
37
Parity Type None
38
Stop Bit Select 1 Stop Bit
39
Data Bits (ASCII Format) 8-Bit
39
Check Receive Errors Enable
40
Hardware Handshaking None
42
Software Handshaking None
44
Host Serial Response Time-out 2 Sec
45
RTS Line State Low RTS
46
Beep on <BEL> Disable
46
Intercharacter Delay 0 msec
47
Nixdorf Beep/LED Options Normal Operation
48
Ignore Unknown Characters Send Bar Code
48