Filter
Top Products
RS-232
32 QuickScan
®
L
Connecting an RS-232 Interface
This connection is made directly from the scanner to the host computer.
Figure 8. RS-232 Direct Connection
1. Attach the modular connector of the RS-232 interface cable to the cable interface port on
the scanner (see Installing the Interface Cable on page 6).
2. Connect the other end of the RS-232 interface cable to the serial port on the host.
3. Connect the power supply
1
to the serial connector end of the RS-232 interface cable. Plug
the power supply into an appropriate outlet.
4. Select the RS-232 host type by scanning the appropriate bar code from RS-232 Host
Types on page 36.
5. To modify any other parameter options, scan the appropriate bar codes in this chapter.
NOTE
Interface cables vary depending on configuration. The connectors illustrated
in
Figure 8 are examples only. The connectors may be different than those
illustrated, but the steps to connect the scanner remain the same.
Serial Port
Connector
to Host
Interface Cable
Power
Supply Cable
1. Use only aDatalogic power supply approved for this product.
NOTE
Refer to
RS-232 Host Commands on page 179 for a listing of host
commands the scanner will respond to when in RS-232 interface mode.