Filter
Top Products
Setting Up Your Printer
22 Allegro2
Other Switches
Switch SW-5: Controls the label edge offset, when the switch is on,
the label edge offset will default to 0250. When the
switch is off, the label edge offset will default to 0220.
Switch SW-6: Present Sensor Option
Switch SW-7: Enables the Internal Batch Software Program. This
program is explained in Chapter 3. There is a software
command that will perform the same option as this
switch; it is the STX g Command.
Switch SW-8: Controls the optional Cutter.
SW-5 Prodigy Compatibility
On Prodigy
Off Allegro
SW-6 Present Sensor Option
On Present Sensor Enabled
Off Present Sensor Disabled
SW-7 Internal Batch Software
On Internal Batch Enabled
Off Internal Batch Disabled
SW-8 Cutter
On Cutter Enabled
Off Cutter Disabled
Table 2-4 Switch Settings and Functions