Filter
Top Products
Use the Parallel menu to change printer settings on jobs sent through a parallel port.
1. From the menu list, use the Arrow buttons
to scroll the Parallel menu.
2. Press the Select button
.
3. Press the Right Arrow button until the heading you want appears on the display, and then press the Select button
.
4. Use the Arrow buttons to scroll through the available menu items.
5. When the setting you want appears on the display, press the Select button
to save the setting.
Advanced Status
Protocol
Honor Init
Parallel Mode 2
MAC Binary PS
Parallel With ENA
Parallel Mode Main Menu
From this
menu:
You can:
PCL
SmartSwitch
Set the printer to automatically switch to PCL emulation when a print job requires it,
regardless of the default printer language.
On*
Off
PS
SmartSwitch
Set the printer to automatically switch to PS emulation when a print job requires it,
regardless of the default printer language.
On*
Off
NPA Mode Send print jobs to the printer and query printer status information at the same time.
Off
On
Auto*
Parallel
Buffer
Assign a size to the parallel input buffer.
Auto*
Disabled
3K to <maximum size allowed> (in 1K increments).
Advanced
Status
Enable bidirectional communication through the parallel port.
On*
Off
Protocol Specify the parallel interface protocol.
Receive information at a much higher transmission rate if the printer is set to
Fastbytes (if computer supports Fastbytes), or receive information at a normal
transmission rate if the printer is set to Standard.