Filter
Top Products
Table2-1 lists the drive indicator patterns established by the SCSI backplane firmware. Different patterns are displayed as drive events occur in the system. For
example, in the event of a hard-disk drive failure, the "drive failed" pattern appears. After the drive is selected for removal, the "drive being prepared for removal"
pattern appears, followed by the "drive ready for insertion or removal" pattern. After the replacement drive is installed, the "drive being prepared for operation" pattern
appears, followed by the "drive online" pattern.
Table 2-1. SCSI Hard-DiskDriveIndicatorPatterns
Redundant Power Supply Features
Each power supply has three indicators which indicate the power-on status, fault, and if there is AC power present. These power supplies are hot-pluggable.
Figure 2-5. Power Supply Features
NOTE: If you do not have the integrated PERC3/Di, or an optional PERC3/DC or PERC3/QC controller installed, you will see only the "drive online" and
"drive bay empty" indicator patterns.
Condition
Indicator Code
Identify drive
All three drive status indicators blink simultaneously.
Drive being prepared for removal
The three drive status indicators flash sequentially.
Drive ready for insertion or removal
All three drive status indicators are off.
Drive being prepared for operation
The drive online indicator is on. The drive activity light may flash briefly.
Drive bay empty
All three drive status indicators are off.
Drive predicted failure
The drive online indicator is on. The drive failure indicator blinks on briefly each second.
Drive failed
The drive online indicator turns off. The drive failure indicator blinks off briefly each second.
Drive rebuilding
The drive online indicator blinks rapidly.
Drive online
The drive online indicator is on.