Dell 2500 Computer Accessories User Manual


  Open as PDF
of 85
 
Insert the hardware key into the socket and secure the key with the latches on each end of the socket (see Figure6-19).
Figure 6-19. Installing the RAID Key
8. Install the RAID battery (see "Installing the RAID Battery").
9. Replacethecoolingshroudandsystemcover;reconnectthesystemandperipheralstotheirpowersourcesandturnthemon.
10. Install the RAID software.
For details, see the RAID controller documentation.
Installing the RAID Battery
1. Hook the front edge of the battery assembly into the slot in the bay, then snap the back edge of the battery assembly into place so the battery lies flat in the bay
(see Figure6-20).
2. Connect the battery cable to the RAID battery connector (RAID_BTRY) on the system board (see Figure6-1).
3. Install the peripheral bay (see "Installing the Peripheral Bay").
Removing the RAID Battery
1. Open the front bezel (see "Removing the Front Bezel" in "Troubleshooting Your System").
2. Remove the system cover.
3. Remove the peripheral bay (see "Removing the Peripheral Bay").
4. Disconnect the battery cable from the RAID battery connector (RAID_BTRY) on the system board (see Figure6-1).
5. Press the release clip on the RAID battery and lift straight up to clear the system (see Figure6-20).
Figure 6-20. Removing and Installing the RAID Battery
 previous next