Filter
Top Products
Removing and Installing Parts 131
7
Place the card in the connector and press down firmly. Ensure that the card
is fully seated in the slot.
8
Replace the support bracket (see "Replacing the Support Bracket" on
page 173) and then press down the card retention bracket to seat it on its slot.
9
Ensure that:
• The guide clamp is aligned with the guide notch.
• The tops of all cards and filler brackets are flush with the alignment bar.
• The notch in the top of the card or filler bracket fits around the
alignment guide.
1 alignment bar 2 fully-seated card 3 not fully seated card
4 alignment guide 5 bracket within slot 6 bracket caught outside of slot
2
3
6
5
4
1
book.book Page 131 Monday, October 6, 2008 11:38 AM